Electromagnet holding 12V 1W 1kgf

A holding electromagnet which, after applying a voltage pulse of 12 V , maintains a mass of 1 kg (at standard gravitational acceleration of 9.8 m/s 2 ). The current consumption during operation of the device is approximately 80 mA. The rated power is 1 W. The electromagnet has dimensions: 13 x 30 mm. It has terminals in the form of two wires, approximately 30 cm long, with the insulation removed at the ends. The housing has an installation hole with an M3 thread. The kit also includes the appropriate screw. The device can be used as an actuator controlled by Arduino . Because the electromagnet draws too much power, it cannot be connected directly to the pins of the microcontroller. One of the following solutions should be used: relay , optocoupler or transistor amplifier .

Holding electromagnet 12V 1W 1kgf .

Electromagnet holding a load .

• Supply voltage: 12V
• Power: 1W
• Current consumption: approx. 80 mA
• Load capacity: 1 kgf (holds a mass of 1 kg for a gravitational acceleration of 9.8 m/s 2 )
• Cables with stripped insulation at the ends, approx. 30 cm long
• Mounting hole with M3 thread (screw included)
• Dimensions: 13 x 30 mm
• Weight: 20 g

Attention !

The manufacturer recommends maintaining good heat dissipation from the housing, because as the coil temperature increases, the holding force decreases.

• Load capacity diagram of electromagnets