RP2040 CAN Bus Feather - CAN Bus Module with RP2040 Microcontroller - MCP2515 - STEMMA QT - Adafruit 5724

Adafruit RP2040 CAN Bus Feather is a versatile development board that has a built-in RP2040 microcontroller and MCP2515 chip and enables communication in the CAN bus standard at a speed of up to 1 Mbps. The board is equipped with a 5 V voltage generator and can operate in various voltage environments, and the 3.5 mm screw connector allows you to quickly connect wires to the board without the need for soldering. Additionally, the device includes a built-in charger for lithium-polymer batteries and an LED indicating the cell's charge level.

RP2040 CAN Bus Feather - CAN Bus module with RP2040 microcontroller - MCP2515 - STEMMA QT - Adafruit 5724.

The module is used for communication and data transfer with the CAN bus.

• It enables communication via the CAN network thanks to the built-in MCP2515 controller
• It is programmed using Arduino and CircuitPython
• It supports data transmission at a speed of up to 1 Mbps on the CAN bus
• It is equipped with a 5 V voltage generator, enabling operation with various voltage levels
• It has a screw connector for easy CAN connection without the need for soldering
• Includes a built-in charger for lithium-polymer batteries with LED indicator
• It allows for versatile expansion thanks to 21 GPIO pins
• It supports numerous interfaces including I2C, SPI, UART and PWM
• It is equipped with a USB type C connector
• Includes a STEMMA QT connector for I2C communication

• Microcontroller chip: RP2040
  • Core: ARM Cortex-M0+ Dual-Core 133 MHz
  • RAM: 264 kB
  • Built-in QSPI Flash memory: 8 MB
  • Communication interfaces: 2x I2C, 2x SPI, 2x UART, 4x ADC, 16x PWM
• Built-in CAN bus chip: MCP2515
• Supply voltage: 3.3 V
• GPIO: 21 pins
• USB connector: USB type C
• Voltage regulator: 3.3V, maximum output current 500 mA
• Voltage generator: 5V
• Pinouts: STEMMA QT connector, 3.5 mm screw connector
• Additional features: charging status LED, NeoPixel RGB LED, Reset and Bootloader buttons
• Dimensions: 52.2 x 22.8 x 12 mm
• Weight: 6.5 g

• 1x CAN Bus Feather development board - MCP2515 - RP2040 - STEMMA QT - Adafruit 5724
• 2x 2.54 mm goldpin strip for self-soldering

Elements included in the set.