Arduino Pro Mini 328 module - 3.3 V/8 MHz - SparkFun DEV-11114

Bestseller
46852314
76 GEL
  • Brand SparkFun
  • Shipping from Poland
  • Post delivery July 20
  • Shipping cost for orders to Georgia from GEL 193

Properties

UC - I2C
yes
UC - RAM
2 kB
UC - A/C
10-bit
UC - UART
yes
UC - ядро
8-bit AVR, 1. Single Core
UC - EEPROM
1 kB
Voltage From
12.0 V
UC - Вспышка
32 kB
UC - аналог в
8
UC - SPI Interface
yes
UC - microcontroller
ATmega328
Выходное напряжение до
3.3 V
UC - Цифровые контакты
14
Выходное напряжение от
3.3 V

General characteristics

UC - PWM
6
Voltage To
3.35 V
UC - frequency
8 MHz

Other features

Brand
SparkFun

Power

Nominal output voltage
3.3 V

Description

Description

Arduino Pro Mini module is based on the popular Uno. The board containsan ATmega328 microcontroller equipped with 14 digital I/o, 6 of which can be used as PWM outputs (e.g. for motor control) and 8 analog inputs. The system works with the clock signal with the frequency of 8 MHz, working voltage is 3.3 V, 32 KB Flash memory and 2 KB RAM SRAM.

          

Unlike theArduino Pro, Arduino Pro Mini version has no connectors, preserving the small size. The user decides which I/O will be needed.

 

This version works with a voltage of 3.3 V at a frequency of 8 MHz.

In our offer you will also find module Pro Mini 5v / 16 MHz.

For programming the tile, you will needa converter USB - UART.

  Specification
  • Supply voltage: from a 3.35 V to 12 V
  • Microcontroller: ATmega328
    • Maximum clock frequency: 8 MHz
    • SRAM: 2 KB
    • Flash memory: 32 KB (5 KB is reserved for bootloader)
    • EEPROM: 1 KB
  • Pins I/O: 14
  • PWM channels: 6
  • Number of analog inputs: 8
  • Serial interfaces: UART, SPI, I2C
  • External interruptions
  • Protection from supplying too much current
  • Module is made on the laminate, 0.8 mm thick
  • Mass - below 2 g
  • Dimensions: 33 x 18 mm

 

Power

If the voltage is higher than 3.3 V, you should connect them to the I/O of RAW, which is connected to stabilizer. VCC is directly connected to the pins of the microcontroller, connecting the voltage which is higher than 3.3 V, may permanently damage the system.

              

Programming

Creating and uploading software, allowsfree environmentsupplied by the manufacturer. This tile doesn't have a system that controls USB interface. Therefore, the adapter UART - USB is necessary for programming.

 

Useful links
  • The website of the manufacturer: SparkFun DEV-11114
  • Getting started
  • Software
  • Diagram of the module
  • Program files of Eagle
  • Documentation of the programming language
  • Documentation for the Atmega328