Cytron MD10 - 1-channel motor driver 30V/10A - Shield for Arduino

Shield forArduinowith single-channel driver for DC motors operating with a voltage from 7 V to 30 V and current up to 10 A (short term 15 A). It has NMOS H-Bridge. The board has jumpers for selecting PWR and DIRpins.

The subject of the sale is a shield,the Arduino Unocan be purchased separately.

1. Digital connectors of Arduino.
2. Output to control other types of microcontrollers.
3. Test button B - when pressed, the current will pass from the output B to A, and the motor will be spinning clock-wise or counter-clockwise, depending on the connection.
4. Test button - after clicking it, current will pass from the output A to B, and the motor will rotate clock-wise or counter-clockwise, depending on the connection.
5. The analog inputs of the Arduino.
6. The power connector of the Arduino.
7. Reset Button.
8. Red LED B.
9. Red LED A.
10. The green power LED.
11. Clamping connections:
    1. Power +
    2. Power -
    3. The output of the motor A
    4. The output of the motor B
12. Jumper to select the PWM pin: D3, D5, D6, D9, D10 or D11.
13. Jumper to select the DIR pin: D2, D4, D7, D9, D12 or D13.

• Supply voltage: from 7 V to 30 V
• Amperage: 10 A (short-time 15 A for up to 10 seconds)
• Voltage of logic level: 3.3 V and 5 V
• Frequency of speed control PWM: up to 10 KHz
• NMOS H-Bridge
• PWM and DIR pins' selection
• The number of controlled motors: 1
• Dimensions: 76 x 56 mm

• Website of the manufacturer: Cytron SHIELD - MD10
• The user manual
• Sample code for Arduino