DFRobot RGB LED driver - Shield for Arduino

Shield for Arduino allows you to control multi-color RGB LED strip. Circuit board has 3 PWM output for each color component of RGB, it is also equipped with an IR receiver, which enables remote control using the remote control. Maximum load on each output is 3 A, which means that the driver can control the LED RGBpanel from approx. 10 meters, which consumes current up to 10 A. An  additional advantage is the fuse that protectsthe LED stripfrom damage.

The subject of the sale is a shield only,Arduino modulesand LED strips can be purchased separately.

The product is compatible with Arduino

Sample code and detailed information can be found inthe user guide.

• Shield works with RGB LED strips 12 V on joint anode
• Also works with strips LED monochrome (with white light)
• Recommended power: 72 V - 2 A per channel (max. 3 A)
• Possibility of operating panel LED RGB from 10 m
• Control via the IR port (built-in IR receiver)
• Board works with Arduino Uno, Mega and derivatives
• Insights pins of the Arduino:
  • D9: output of the blue channel
  • D10: output of the red channel
  • D11: the output of the green channel
  • D4: pin IR receiver
• Board sizes: 65 x 55 x 15 mm

Boards are suitable for theArduino connectorsand allow mounting of subsequent shields.

The manufacturer recommends to power the system with 12V connected to the DC on the LED RGBdriver, which wil also power the Arduino and protect them from overload with a built-in fuse.

• The website of the manufacturer DFRobot DFR0274
• User manual WikiDoc
• Diagram of the module