Display e-paper - 1.64'' 168x168px - 4 colors - SPI - Waveshare 22755

Bestseller
60982242
82 GEL
  • Brand waveshare
  • Shipping from Poland
  • Post delivery June 13
  • Shipping cost for orders to Georgia from GEL 184

Properties

Design

(image-) diagonal
1.64 "

Display

Touchscreen
No
Screen resolution
168x168px

Other features

Brand
waveshare

Экран

Screen Display
e-paper

Description

Product description: E-paper display - 1.64'' 168 x 168 px - 4 colors - SPI - Waveshare 22755

Waveshare display made on the basis ofe-paper technology, which makes this type of display suitable for e-book readers and electronic magazines. The diagonal of the screen is 1.64 ", and the resolution is 168 x 168 px . The image is displayed in four colors : red, yellow, black and white. The screen uses the SPI interface for communication purposes and works with boards such as Raspberry Pi, Jetson Nano , Arduino, STM32, etc.

Product compatible with Arspberry Pi and Arduino! The manufacturer provides a product wiki page , which contains information about the pins of the module and a detailed user guide - check it out!

E-paper display - 1.64'' 168 x 168 px - 4 colors - SPI - Waveshare 22755.

e-paper technology.

What is the "e ink e paper" display?

The e-paper display, also known as e-paper display, uses electrophoretic microcapsule technology to present data. This means that it mimics the appearance of standard ink found on traditional paper. This type of technology is extremely user-friendly - screens do not emit blue glow, are passively reflective and provide a wide viewing angle. All these features mean that our eyesight does not get tired so much during use, and reading is even more enjoyable than before.

Main features of the e-paper screen
  • No backlight, it displays the last content for a long time, even when the power is disconnected
  • Very low power consumption, power only required to refresh the image
  • SPI interface, compatible with Arduino , Raspberry Pi , STM32 , etc.
  • Built-in voltage regulator compatible with 3.3V/5V boards
Pin description

At the back of the display there is a connector with leads, so there is no need to solder the connectors. Just connect the display using the cable included in the set in accordance with the following relationships:

  • VCC - supply voltage
  • GND - system ground
  • DIN - MOSI line of the SPI bus
  • CLK - SCK line of the SPI bus
  • CS - chip select (activated low)
  • DC - data / command selection pin (high state for data, low state for commands)
  • RST - reset, activated by low state
  • BUSY - output pin of the busy state, activated high

On the back of the display there is a connector with leads.

The screen has a square shape with a diagonal of 1.64''.

e-paper display specification
  • Supply voltage: 3.3 V or 5 V
  • Interface: SPI
  • Display color: red, yellow, black and white
  • Diagonal: 1.64''
  • Resolution: 168 x 168 pixels
  • Grayscale: 2
  • Full refresh time: 12 sec
  • Refresh power consumption: less than 57mW
  • Standby current consumption: less than 0.01 uA
  • Viewing angle: over 170°
  • Pixel dimensions: 0.176 × 0.176 mm
  • Module dimensions: 47 × 38 mm
  • Display dimensions: 29.568 × 29.568 mm
Kit contents
  • E-paper display - 1.64'' 168 x 168 px - 4 colors - SPI
  • 8-pin connection cable, 20 cm long
Useful links
  • Manufacturer website: Waveshare 22755
  • Product wiki page