DRV8838 - single-channel motor controller 11V/1,7A - Pololu 2990

Bestseller
47398074
32 GEL
  • Brand Pololu
  • Shipping from Poland
  • Post delivery July 10
  • Shipping cost for orders to Georgia from GEL 178

Properties

Voltage To
1.8 V
Voltage From
1.5 V

Features

Channel
1

Other features

Brand
Pololu

Power

Current
1.7 A

Description

Description: PololuDRV8838 - single channel motor controller 11V/1.7A

The module based on theDRV8838allows to control one DC motor. The motor can be supplied with a voltage of up to 11 volts with a continuous current consumption of up to 1.7 A, and temporarily (for a few seconds) up to 1.8 A. We recommend that you readthe DRV8838's documentationbefore use.

Connection

Connect the motor supply voltage from 0 to 11 V to the VIN input. If the voltage is low (less than 1.5 V) it can be connected to the VMM output, this will bypass the reverse connection protection and compensate for the voltage drop. The power supply for the logical part from 1.8 V to 7.0 V is supplied to the VCC pin.

In a typical application, simply connect two control lines: PHASE direction selection and PWM speed control to the ENABLE pin. Both lines are internally pulled to ground by a resistor approximately 100 kΩ.

The SLEEP output enables the system to switch to low power mode. By default, the pin is pulled up to VCC via 10 kΩ, which means that the circuit is switched on. To switch to the Sleep mode, the low state must be specified.

PHASE ENABLE SLEEP OUT1 OUT2 Mode of operation 0 PWM 1 PWM L forward speed PWM %braking 1 PWM 1 L PWM Reverse speed PWM %braking X 0 1 L L

Stop,

outputs connected to ground

X X 0 Z Z free runningoutputs disconnected

1 - high state, 0 - low state

Exits PIN Description

VIN

Motor supply voltage from 0 V - 11 V with reverse connection protection. GND The weight of the module. VCC Supply voltage of the logical part from 1.8 V to 7 V. VM Motor supply voltage from 0 V - 11 V without reverse connection protection. OUT1 Outputs 1 to connect the motor outputs. OUT2 Outputs 2 to connect the motor outputs. PHASE Logical input defining the direction of engine rotation. Default is in low state. ENABLE Logical input for speed setting. A PWM signal must be connected to this output. Default is at low state. SLEEP Logical input that switches the system to the sleep state when low state is given. Default is high state.

Outputs are standardgoldpin strips, allowing the module to be plugged into thecontact boardor connected bywires.

Comparison of Polol controllers.

Polol specificationDRV8838
  • Number of channels: 1
  • Supply voltage: 0 V to 11 V
  • Operating voltage of the logical part: 1.8 V to 7.0 V
  • Continuous current per channel: 1.7 A
  • Maximum instantaneous current per channel: 1.8 A
  • PWM frequency: 250 kHz
  • Dimensions: 10.2 x 12.7 mm
  • Weight: 0.3 g (without connectors)
  • Included module and goldpin connectors
Useful links
  • Polol manufacturer's website #2990
  • Diagram of the DRV8838 module
  • DRV8838 system documentation