Gravity - 1 kg (10 N) digital pressure sensor - HX711 - Build a scale kit - DFRobot KIT0176
- Product Code:
- 111100302
Properties
Other features
- Brand
- DFRobot
- Transducer Type
- force
Description
A set of self-assembly components that allow you to make an electronic scale. The kit contains a digital pressure sensor, in the form of a strain gauge bar, detecting pressure from 1 g to 1 kg (10 N). In addition, the manufacturer has also included a signal converter with a built-in HX711 chip. When assembled, the scale has dimensions of 120 x 100 x 30 mm.
This product is compatible with Arduino and Raspberry Pi!
Detailed user guide is available on manufacturer website - check it out!
Assembled scale kit with 1 kg (10 N) pressure sensor from DFRobot.
Elements of the scale kit from DFRobot.
- Complete accessories for a convenient and fast scale build
- Built-in calibration algorithm - calibrate at the touch of a button or via API, see user guidefor more details
- Compatible with Arduino series, micro:bit, ESP32, Raspberry Pi and other controllers working with 3.3 V and 5 V
- Can be used as a simple electronic scale or as an everyday kitchen scale
- Pressure sensor - strain gauge bar 1 kg (10 N)
- Analog to digital converter
- 4-pin cable with Gravity connector
- Acrylic caps to build the scale
- Mounting screws
- M4x20 cm - 2 pieces
- M5x20 cm - 2 pieces
- M3x8 cm - 2 pieces
- Non-slip feet - 4 pieces
- VCC - power supply pin
- GND - system ground
- SCL - I2C interface clock line
- SDA - I2C interface data line
- CAL - auto calibration button
- RST - reset button
- E+ - sensor connection (power: red wire)
- E- - sensor connection (ground: black wire)
- S- - sensor connection (white lead)
- S+ - sensor connection (green wire)
- Type: pressure sensor
- Type: digital
- Measuring range: from 1 g to 1000 g
- Supply voltage: 3.3 V / 5 V
- Current consumption: < 20 mA
- Built-in AD conversion circuit: HX711
- Synthesis deviation: ± 0,2% g
- Communication interface: I2C bus
- Interface address: 0x64 / 0x65 / 0x66 / 0x67
- Built-in one-touch calibration algorithm
- Compatible with Arduino, micro:bit, ESP32, Raspberry Pi
- Board dimensions: 37 x 31 mm
- Total dimensions of the scale after assembling the kit: 120 x 100 x 30 mm
Analog to digital converter with Gravity connector.
For proper scale operation a control board is required, which is not included in the set: Arduino, Raspberry Pi, ESP32, micro:bit or other working with 3.3 V or 5 V.
- Manufacturer's website: DFRobot KIT0176
- User guide
- HX711 library for Arduino IDE
