Grove - temperature and humidity sensor DHT11 - Seeedstudio 101020011
- Product Code:
- 54468854
Properties
- Датчик - Температура до
- 50 °C
- Датчик - Температура от
- 0 °C - 70 °C
- Точность измерения температуры датчика
- +/- 2 °C
Features
- Connection
- Digital I / O
Other features
- Brand
- SeeedStudio
- Transducer Type
- temperature, humidity
Description
The sensor of temperature and humidity DHT11 from the Grove series with a digital interface. The output is a digital signal. The temperature measurement range is from 0 °C to 50 °C and humidity is from 20 to 90% RH.
Attention!
This product is only available in our market in Poland and cannot be sold to other countries.
The product is compatible with Arduino
The manufacturer offersthe user guide and on the GitHub is library for Arduino.
PinsThe system has four pins on a special connector to which the cable is not included in the package.
The distribution of elements on the board.
Pin Description VCC Supply voltage from 3.3 V to 5 V. GND The ground of the system. NC Not connected. SIG The sensor's signal.
The sensor is compatible with the Raspberry
Our offer also has a shield for the Raspberry facilitating the sensors from the Grove series.
The manufacturer has prepared auser guidefor those wanting to support the sensor using the Raspberry.
Specification- Supply voltage: from 3.3 V to 5 V
- Measuring range:
- Humidity: 20% to 90% RH
- Temperature: 0 °C to 50 °C
- Measurement accuracy:
- Humidity: ± 5 % RH
- Temperature: ± 2 °C
- Communications: digital signal
- Dimensions: 40 x 20 x 8 mm
- Weight: 10 g
- The manufacturer's site: Seeedstudio 101020011
- Wiki site
- Eagle files
- Library for Arduino
- CDC file
- Grove system
- Introduction for Grove
- Blog Seeedstudio
- Grove selection guide
