Highsider Can-Bus Resistor
Bestseller
- Product Code:
- 137922145
Out of stock
Properties
Other features
- Brand
- Highsider
Weight & dimensions
- Width
- 166 mm
- Length
- 275 mm
- Height
- 142 mm
- Weight
- 4.61 kg
Description
Highsider CAN-BUS resistor CBW1 with DIP-switch.
Our newly developed HIGHSIDER CAN-BUS resistor CBW1 fits most vehicles that have a CAN-BUS system.
The CBW1 resistor provides a required electrical load for your vehicle, which, if the dip switches are set correctly, will result in no flashing of the accessory flashers in the cockpit.
In addition, reliability is given. This means: If the accessory indicators fail due to an electronic fault, an error message is immediately displayed in the cockpit.
Up to 2 channels can be operated, such as turn signals at the rear left and turn signals at the rear right.
If 2 pairs of indicators need to be changed, also 2 CBW1 needs to be used.
Which requirements should be met to use the CBW1 on the motorbike:
The motorbike was originally produced with LED indicators, or the motorbike has a CAN-BUS System
If these requirements are not met, the CBW1 unit will not function (!) In this case, we recommend the following resistances:
For indicators with 21 Watt:6,8 Ohm part number 1108546002 or 10 Ohm part number 1108546004
For indicators with 10 Watt:27 Ohm part number 1107562
The following resistance values can be set on the CBW1:
150 ohms
170 ohms
240 ohms
300 ohms
400 ohms
600 ohms
1200 ohms
Dimensions: Height = 11mmWidth = 31mm (without straps) Width = 46mm (with tabs) Length = 40mm
Cable length = 200mm with pins
Connections: Yellow = input channel 1 (+) Orange = output channel 1 (+) Blue = input channel 2 (+) Red = output channel 2 (+) Gray = input mass (-) Black = output ground (-)
Hints: Up to 2 channels can be operated. The connection is explained precisely in the mounting instructions!