Soldering station 2in1 hotair and grotto ATTEN AT-8586 with fan in flask 750W
- Product Code:
- 47170557
Properties
- Voltage To
- 230 V
- Voltage From
- 230 V
Features
- Temperature
- 150 - 480°C
General characteristics
- Promotion
- BF20
- Лаборатория будущего
- Compatible
- Паяльник - Вентилятор
- yes
- Припой - Горячий воздух
- yes
- Кондиционер паяного типа
- Цифровой
- Припой - показания реальной температуры
- yes
Other features
- Brand
- Atten
Power
- Rated power
- 750 W
Description
A device combining the function of asolderingtip of50 Wwitha hotairstationof 700 W. The operating temperature of the soldering tip can be adjusted within the range from 150°C to 480°C. The maximum hot air blowing temperature (hotair) is 500°C. The ATTEN AT-8586 has a single digital display, showing values for the current operating mode. Adjustment of the operating parameters is done with a precise knob and buttons located on the front of the housing. The station can be used to solder SMD components and remove them from prototype boards.
In the offer of our shop there is a large selection of solderingstationsandaccessoriesnecessary during the soldering.
Front panel of the ATTEN AT-8586soldering station.
- The ATTEN AT-8586 combines the advantages of a traditional soldering station, equipped with a soldering iron and hot air blowing device
- Can be used for SMD soldering and removal of SMD components from prototypes using a hotair
- LED display showing the current operating temperature values
- Control by a precise knob and function keys
- LEDs indicating the current operating mode
- Iron heater with low voltage to effectively protect sensitive electronic components
- Intelligent cooling system and delayed shut-off function to extend the life of the device
- Auto sleep function to save energy
- Intelligent fault detection and signalling
- Digital airflow step control (A25-A99)
Initial start up
- When the equipment is delivered, do not immediately start it up.
- The equipment should be left for approximately 12 hours at room temperature before start-up.
- Any defect report caused by premature startup of the equipment will be rejected.
Hot Air Soldering Machine Specifications
- Power: 700 W
- Working temperature range: from 100°C to 500°C
- Air flow stages: A25-A99
- Air flow rate: 120 litres/minute
- Air flow source: fan
Soldering tip specifications
- Power: 50 W
- Working temperature range: from 150°C to 480°C
- Temperature stability: ± 2°C
- Grounding impedance: below 2 Ω
- Grounding voltage: less than 2 mV
Components of ATTEN AT-8586.
ATTEN AT-8586 2-in-1 Hotair and Soldering Station
- Supply voltage 230 V AC / 50 Hz
- Total power: 750 W
- Recommended operating temperature: from 0°C to 40°C
- Temperature control: precise knob, buttons
- Soldering station ATTEN AT-8586 : 1 pc.
- Soldering iron holder 1 pcs.
- Hot air holder : 1 pc.
- Power cord: 1 pcs.
- Blade cleaning sponge: 1 pcs.
- Hotair tips: 3 pcs.
- Manufacturer's website
- User manual
