Soldering station 2in1 hotair and soldering iron WEP 852D+ with fan
Bestseller
- Product Code:
- 53055213
296 GEL
Properties
- Voltage To
- 220 V AC
- Voltage From
- 240 V AC
- Паяльник - Вентилятор
- yes
- Кондиционер паяного типа
- Цифровой
- Припой - показания реальной температуры
- yes
Features
- Temperature
- 200 - 480 °C
General characteristics
- Припой - Горячий воздух
- yes
Other features
- Brand
- WEP
Power
- Rated voltage
- 230 V AC
Description
Product description: Soldering station 2in1 hotair and tip-based WEP 852D+
Tip-base soldering iron and hot air iron. The device has continuous temperature control and two LED displays. System ESD Safe provides security for the solder joint elements. The air flow is provided through a fan located in the iron.
Check out our offer of additional tips!
Specification of soldering station WEP 852D+- Power supply: AC 220 V - 240 V, 50 Hz (network)
- The system is ESD Safe
- Included 3 pieces of round nozzles with a diameter of 5mm, 7mm, 9mm
- Continuously adjustable temperature of hot air in the range from 100 °C to 480 °C
- Two LED displays, showing the set temperature
- Temperature setting buttons
- Fan performance: do120 l/min
- Adjustable air supply with regulator
- The air flow is provided through a fan located in the handle
Soldering Iron Tip-based
- Smooth adjustment of temperature of the iron in the range 200-480V°C
- The power of the iron 60 W
Included
- Soldering station WEP 852D+
- Stand for hotair iron
- Stand for tip-based iron along with a sponge to clean the soldering tip
- Soldering iron
- Nozzles hotair:
- round with a diameter of 5 mm
- round with a diameter of 7 mm
- round with a diameter of 9 mm
- Power cable
First run
- Youi should not run the device immediately after delivery.
- Equipment must remain for about 12 hours at room temperature before switching on.
- All complaints caused by running of the equipment too soon will be denied.
- You must completely remove the screw/screws from the bottom station if the source of air supply is the compressor. These screws are marked in red (1 or 3 screws depending on model).
- soldering tin of various diameters
- fluxes and rosins
- braids to remove excess tin
- suckers
- soldering tips
- tweezers, holders, magnifying glass
- sponges and cleaners
