Soldering station 2in1 hotair and soldering iron WEP 898BD+ with fan in iron - 700W
Bestseller
- Product Code:
- 47170567
333 GEL
Properties
- Voltage To
- 220 V AC
- Voltage From
- 240 V AC
- Припой - Горячий воздух
- yes
- Кондиционер паяного типа
- Цифровой
- Припой - показания реальной температуры
- yes
Features
- Temperature
- 200 - 480 °C
General characteristics
- Паяльник - Вентилятор
- yes
Other features
- Brand
- WEP
Power
- Rated power
- 700 W
- Rated voltage
- 230 V AC
Description
Description
Station WEP 898BD has two LED displays, which can read the temperature for hot air and tip-based soldering iron. The temperature of the tip and the air is carried out using the buttons, adjustment of the fan with a regulator.
The device has a sensor in the base that, when you put the iron down, the station cools down the heating element in a time from 3 to 8 minutes, then the device enters a low energy consumption mode (the so-called standby mode). This mode allows to save energy, prolong the service life of the heater and increases safety. Station remembers the set temperature.
Check out our offer of additional tips!
Specification- Supply voltage: 230 V / 50 Hz (network)
- Power: 700 W
- The station is controlled by the microcontroller which ensures a high stability
- The device has a standby mode
- Remembers the set temperature
- Equipped with ergonomic housing
- Adjustable temperature hot air from 100 °C to 480 °C
- Temperature stability +/-1 °C
- LED display
- Temperature setting buttons,
- Infinitely adjustable air supply with regulator
- Air flow up to 120 l/min
- The head size of the hot air 22 mm
- The air flow is provided through a fan located in the handle
- Soldering iron 907F
- Regulation of the soldering tip temperature from 200 °C to 480 °C
- Power: 75 W
- Temperature stability +/- 1 °C
- Soldering station WEP 898BD+
- Stand for the hotair iron
- Set of nozzles:
- round with a diameter of 7 mm
- round with a diameter of 9 mm
- square 12x12 mm
- Stand for the tip-based iron along with a cleaning sponge
- Soldering iron 907F with T-B tip
- A gripper for lifting circuits
First run
- You should not run the device immediately after delivery.
- Equipment must remain for about 12 hours at room temperature before switching on.
- All complaints caused by running of the equipment too soon will be denied.
- You must completely remove the screw/screws from the bottom station if the source of air supply is the compressor. These screws are marked in red (1 or 3 screws depending on model).
Note
Heating elements (heaters) and the tips are not subject to warranty, and you must purchase new ones.
Our range of accessories for soldering:- soldering tin of various diameters
- fluxes and rosins
- braids to remove excess tin
- suckers
- soldering tips
- tweezers, holders, magnifying glass
- sponges and cleaners
