Soldering station 2in1 hotair and tip-based WEP 898BD with fan in iron - 740W

Station WEP 898BD has two LED displays, which can read the temperature of hot air and soldering iron. Temperature adjustment is done using buttons, the fan is adjusted with a regulator.

The device has a sensor in the base that, when you put the iron down, the station cools down the heating element, and then the device enters a low energy consumption mode (the so-called standby mode). This feature allows you to save energy, prolongs the life of the heater and increases safety. Station remembers the set temperature.

Stable and effective air flow is provided through a fan located in the iron. The fan is driven by a brushless motor, which provides a much higher durability and reliability of the device.

Check out our offer of additional tips!

• Supply voltage: 220 V - 240 V / 50 Hz (network)
• Power: 740 W
• The station is controlled by the microcontroller which ensures a high stability
• The device has a standby mode
• Remembers the set temperature
• The station has an ergonomical body

• Adjustable temperature hot air from 100 °C to 480 °C
• Temperature stability +/-1 °C
• LED display
• Temperature setting buttons
• Adjustable air supply with regulator
• Air flow up to 120 l/min
• The head size of the hot air 22 mm
• The air flor is provided through a fan located in the handle

• Solderin iron 907A
• Regulation of the soldering tip temperature from 200 °C to 480 °C
• Capacity: 60 W
• Temperature stability: +/- 1 °C

• Station WEP 898BD
• Stand for the hotair iron
• Set of nozzles:
  • round, diameter 6 mm
  • round, diameter of 9 mm
  • square 12x12 mm
• Stand for the tip-based iron along with a cleaning sponge
• Solderin iron 907, with tip T-I
• A gripper for lifting circuits

First run

• You should not run the device immediately after delivery.
• Equipment must remain for about 12 hours at room temperature before switching on.
• All complaints caused by running of the equipment too soon will be denied.
• You must completely remove the screw/screws from the bottom station if the source of air supply is the compressor. These screws are marked in red (1 or 3 screws depending on model).

Note

Heating elements (heaters) and the tips are not subject to warranty, and you must purchase new ones.

• soldering tin of various diameters
• fluxes and rosins
• braids to remove excess tin
• suckers
• soldering tips
• tweezers, holders, magnifying glass
• sponges and cleaners