Soldering station 3in1 hotair and tip-based + power supply 15V/1A WEP 853DA
Bestseller
- Product Code:
- 47170569
421 GEL
Properties
- Voltage To
- 220 V AC
- Voltage From
- 240 V AC
- Припой - Горячий воздух
- yes
- Кондиционер паяного типа
- Цифровой
- Припой - показания реальной температуры
- yes
Basic information
- Rated power
- 800 Вт
Features
- Temperature
- 200 - 480 °C
General characteristics
- Паяльник - Вентилятор
- yes
Other features
- Brand
- WEP
Power
- Rated voltage
- 230 V AC
Description
Description
Station 853DA is the combination of hot air iron, tip-based soldering iron and power supply 15V/1A. The device has a smooth adjustment of power and temperature of the airflow and temperature adjustment of the tip with the buttons. The parameters are displayed on LED displays.
The station is controlled with a microcontroller, it has a cooling system of the heaterbefore shutting down and remembers the set temperature. It allows reading the real temperature of the hot air. All of the five modules can work independently.
Specification- Supply voltage: 230 V / 50 Hz (network)
- Power consumption: 800 W
- The station is controlled through a microcontroller that provides high stability
- The station has read the real temperature value of hot air
- Compact design with LED displays
- Dimensions: 185 x 175 x 25 mm
- The weight: 4.2 kg
- Soldering Iron Hotair:
- Blowing air through the compressor inside the station
- Adjustable temperature hot air in the range: 100 to 480 °C
- Temperature stability: +/-1 °C
- Temperature setting buttons,
- Maximum air capacity up to 24 litres/minute
- The real temperature value of hot air
- Adjustable air supply with regulator
- Soldering Iron Tip-based
- Adjustable temperature soldering tip: 200°Cto 480 °C
- Temperature stability: +/- 2 °C
- Soldering iron power: 50 W
- The resistance to grounding: up to 2 Ω
- Potential relative to ground: 2 m
- Power supply
- Output voltage: DC 0 - 15V
- Maximum current: 1 A
- Digital LED display
Includes:
- Station WEP 853DA
- Stand for the hotair iron
- Set of nozzles:
- round 2.5 mm
- round with a diameter of 4.4 mm
- round with a diameter of 7 mm
- round with a diameter of 9 mm
- Stand for a tip-based iron along with a cleaning sponge
- Soldering iron witha T-I tip
- A gripper for lifting circuits
- Power cable
First run
- You should not run the device immediately after delivery.
- Equipment must remain for about 12 hours at room temperature before switching on.
- All complaints caused by running of the equipment too soon will be denied.
- You must completely remove the screw/screws from the bottom station if the source of air supply is the compressor. These screws are marked in red (1 or 3 screws depending on model).
- soldering tin of various diameters
- fluxes and rosins
- braids to remove excess tin
- suckers
- soldering tips
- tweezers, holders, magnifying glass
- sponges and cleaners
