Soldering station hotair and soldering iron WEP 995D+ with fan - 720W

• Voltage: 220 - 240 V / 50 Hz (network)
• Power: 720 W
• The station is controlled through a microcontroller that provides high stability
• The device has a PID controller
• Compact design with clear LCD display

• Soldering Iron Hotair:
  • Adjustable temperature hot air from 100 - 480 °C
  • Temperature stability +/-1 °C
  • LCD display showing actual power supply
  • Temperature setting buttons
  • Smooth adjustmentof temperature in the range
  • Air flow up to 120 litres/min[max]
  • The head size of the hot air 22 mm
  • Protection before reaching the high temperature and report alarms.
  • Length of iron cable: up to 100 cm
  • The air flow is provided through a fan located in the iron

• Tip-based Soldering Iron
  • Adjustable temperature soldering tip: 200°Cto 480 °C
  • Temperature stability: +/- 1 °C
  • Soldering iron power: 75 W
  • The resistance to ground of up to 2 Ohms
  • Potential relative to earth ground 2 mV
  • System: ESD safe
  • Sleep mode: activated after idle operation 0-99 minutes.

WEP 995D+ soldering station with hot air iron and tip-based soldering iron. The device has a microcontroller with the applicable block of PID control, which checks the performance and adjusts it to the preset values.

Hotair soldering iron has a ceramic heating element that quickly and evenly heats up. The heater consists of hard alloys, which allows for a long operation time at high temperatures without deformation, which increases the stability and prolongs the service life of the heater.

Choosingautomaticmode, after putting down the hot airiron on the stand, the unit automatically stops heating and cools down to a safe temperature. This saves electricity and prolongs the service life of the device.

Temperature, power, airflow, and operating mode are displayed on a large, easily readable LCD display. The station is equipped with control functions, we get the message about the short circuit, overloading of circuits, lack of a predetermined temperature. All of these errors appear on the display.

• WEP soldering station 995D+
• Stand for hotair iron
• Set of nozzles:
  • round with a diameter of 4.4 mm
  • round with a diameter of 8 mm
  • round with a diameter of 9 mm
  • square 12x12 mm
• Stand for the tip-based iron along with a cleaning sponge
• Soldering iron with T-I tips
• A gripper for lifting circuits

First run

• Youi should not run the device immediately after delivery.
• Equipment must remain for about 12 hours at room temperature before switching on.
• All complaints caused by running of the equipment too soon will be denied.
• You must completely remove the screw/screws from the bottom station if the source of air supply is the compressor. These screws are marked in red (1 or 3 screws depending on model).

• soldering tin of various diameters
• fluxes and rosins
• braids to remove excess tin
• suckers
• soldering tips
• tweezers, holders, magnifying glass
• sponges and cleaners