Soldering station hotair and tip-based 2in1 Yihua 872D+ - 700W

Bestseller

Product Code:: 47170593

Soldering station hotair and tip-based 2in1 Yihua 872D+ - 700W

377 GEL

Brand YIHUA
Shipping from Poland
Post delivery June 9
Shipping cost for orders to Georgia from GEL 176

Properties

Voltage To: 220 V AC
Voltage From: 240 V AC
Паяльник - Вентилятор: No
Припой - Горячий воздух: yes
Кондиционер паяного типа: Цифровой
Припой - показания реальной температуры: yes

Basic information

Rated power: 700 W

Features

Temperature: 100 - 480 °C

Other features

Brand: YIHUA

Power

Rated voltage: 230 V AC

Description

Soldering iron Yihua 872D total capacity of 700 watts with adjustable temperature and built-in PID-regulator. The device has a soldering iron with heating power 50 W. Temperature of soldering iron and hotair iron is set by using the knobs.

The station is used on the electronic repair services for safe soldering of QFP, BGA, SMD,PLCC, and othertemperature-sensitive elements.

Check out our offer of additional tips!

Specification

Supply voltage: 230 V / 50 Hz (network)
Power: 700 W
Station is controlled through the microcontroller for PID control, which ensures high stability
Two LED displays the value of the tip and hotair, every few seconds displays the current temperature

Hotair Soldering Iron

Adjustable temperature hot air from 100 °C to 480 °C
Temperature stability: +/- 1 °C
Temperature setting with knob
Air consumption: max. up to 24 l/min
Display: LCD

Tip-based Soldering Iron

Adjustment of the soldering tip temperature: 100 °C-480 °C
Temperature stability: +/- 2 °C
Potential between tip and ground: < 2mV

The resistance between tip and ground: < 2 Ohm
Iron: 907 F

Soldering iron power: 50 - 100 W
Display: LCD

Includes:

Soldering station Yihua 872D+
Set of nozzle:
- round nozzle with a diameter of 2 mm
- round nozzle with a diameter of 4.4 mm
- round nozzle with a diameter of 6 mm
- round nozzle with a diameter of 9 mm
Standfor the soldering iron along with a cleaning sponge
A gripper for lifting circuis
Soldering iron 907 F with tip I

First run

You should not run the device immediately after delivery.
Equipment must remain for about 12 hours at room temperature before switching on.
All complaints caused by running of the equipment too soon will be denied.

You must completely remove the screw/screws from the bottom of the station if the compressor is the source of air supply. These screws are marked in red (1 or 3 screws depending on model).

Note

Heating elements (heaters) and tips are not subject to warranty, you should purchase new ones.

Our range of accessories for soldering: