Soldering Station WEP 936 NewDesign - 45W

Simple soldering station using tips. It has the temperature adjustment of the soldering tip from200°C to 480°Cusing a knob. Used ceramic heating element ensures long life of the model.

Comparison of soldering station from 936 series.

• Power supply: from 220 V to 240 V
• Power: 45 W
• Temperature adjustment from 200 °C to 480 °C
• Iron: WEP 936
• System: ESD safe
• The potential of the ground on the tip: below 2 mV
• The resistance of the ground one the tip: below 2 Ohms

Check out our offer of additional tips!

• Soldering station 936 WEP NewDesign
• Stand for the iron along with a sponge to clean the soldering tip
• 907A soldering iron with T-I tip
• Warranty: 24-month

First run

• Youi should not run the device immediately after delivery.
• Equipment must remain for about 12 hours at room temperature before switching on.
• All complaints caused by running of the equipment too soon will be denied.
• You must completely remove the screw/screws from the bottom station if the source of air supply is the compressor. These screws are marked in red (1 or 3 screws depending on model).

Note

Heating elements (heaters) and the tips are not subject to warranty, and must purchase new ones.

• soldering tin of various diameters
• fluxes and rosins
• braids to remove excess tin
• suckers
• soldering tips
• tweezers, holders, magnifying glass
• sponges and cleaners