Step-Down Voltage Regulator D24V25F5 - 5V 2,5A - Pololu 2850
- Product Code:
- 47399434
Properties
- Voltage To
- 6.0 V
- Voltage From
- 38 V
- Стабилизатор - Тип
- step-down
- Стабилизатор - Тип 2
- switching
- Выходное напряжение от
- 5.0 V
- Выходное напряжение до
- 5.0 V
Other features
- Brand
- Pololu
Power
- Current
- 2.5 A
- Nominal output voltage
- 5.0 V
Weight & dimensions
- Width
- 18 mm
- Height
- 9 mm
- Length
- 18 mm
Description
A step-down converter (buck) used to supply power to systems operating at 5 V. The advantage of the system is a wide range of input voltages from 6 V to 38 V.
D24V25F5 module allows for current consumption up to 2.5 A. In our offer there is also a step-down system D24V50F5 withmaximumoutput current up to 5 A.
Outputs Pin Description VIN Input voltage from 6.0 V to 38 V. GND Mass potential. VOUT Output voltage. ENABLE If a low voltage of less than 0.6 volts is applied), the system will go into a low power consumption state (approx. 20 μA). The pin is pulled to the supply voltage through a 100 kΩ resistor, which makes the system switched on by default.The connectors are properly signed on the board. Outputs are 2.54 mm (popular goldpin connectors). The module can be plugged into acontactboard,connected with wiresor soldered intoa dedicated PCB.
System efficiencyEfficiency is defined as the ratio of output power to input power (Power out)/(Power in). This is a very important parameter when working with portable energysources(batteries and accumulators), where the time of operation on one charging cycle counts. The efficiency of this pulse system is about 85 % - 95 %.
Voltage drop-outThe parameter referred to in the documentation asvoltag drop-outthennecessary for the proper functioning of the system,minimum difference between input and output voltage.For example, if the drop-out is 1 V and the desired output voltage is 5 V, the supply voltage should be higher than 6 V. The figures below show the drop-out voltage value for D24VxFx inverters.
Specifications of the D24V25F5 Polol step-down converter:- Input voltage: 6* V to 38 V
- Output voltage: 5 V
- Accuracy of output voltage: 4 %
- Maximum input current: 2,5 A
- Efficiency of 85 - 95 %
- Integrated protection against excessive current, voltage and temperature
- Two 2.2 mm diameter mounting holes
- Dimensions: 18 x 18 x 9 mm
- Weight (without connectors): 3,0 g
* minimum value depending on drop-out voltage
Useful links- The manufacturer's website: Polol #2850
