WEP 992D - Soldering station 2in1 hotair and soldering iron

WEP 992D soldering station hot air iron and tip-based soldering iron with capacity of 75 W. The device is equipped with a microcontroller unit with the PID driver, which checks the performance and adjusts it to the preset values. Models 992D are characterized by:

• The operation of the hot air in auto mode- when you put down the iton, the system will turn off the heat and cool the iton to a safe temperature.
• The function of temperature correction depending on external parameters.
• Mode C/Fthe ability to change the units in which temperature is displayed.
• Sleep function of soldering iron tip-based - if the iron is not used the given time interval (0 - 99 minutes) the system switches to sleep mode, that is cooled to a temperature of 200 °C, which ensures long service life of the device.
• Ceramic heating element- soldering iron hotair has a ceramic heating element that quickly and evenly heats up. The heater consists of hard alloys, which allows for a long operation time at high temperatures with no deformation, which increases the stability and prolongs the service life of the heater.
• Easy to read LCD display- temperature, power, airflow and operation mode are displayed on a large, easily readable LCD display.

• Voltage: 220 - 240 V / 50 Hz (network)
• Power consumption: 700 W
• The station is controlled through a microcontroller that provides high stability
• The device has a PID controller
• Compact design with large and clear LCD display

• Soldering Iron Hotair:
  • Blowing air through the compressor inside the station
  • Air consumption: up to 28 L/min
  • Smooth adjustmentof temperature in the range
  • Adjustable temperature of hot air: 100-480 °C
  • Temperature stability: +/-1 °C
  • LCD display showing the actual power and temperature of blowing
  • Temperature setting buttons
  • Protection before reaching the high temperature and inform the alarm
  • Length of iron cable: up to 90 cm

• Tip-based Soldering Iron
  • Iron 908B
  • Adjustable temperature soldering tip: 200°Cto 480 °C
  • Temperature stability: +/- 1 °C
  • Soldering iron power: 75 W
  • The resistance to grounding: up to 2 Ω
  • Potencjał regarding grounding: up to 2 mV
  • System ESD safe
  • Cable length of the iron: up to 100 cm
  • Sleep mode: enabled after idle operation 0-99 minutes

• Station WEP 992D
• Stand for hotair iron
• Set of nozzles:
  • round 2.5 mm
  • round with a diameter of 4.4 mm
  • round with a diameter of 7 mm
  • round with a diameter of 9 mm
  • square 12x12 mm
• Stand for tip-based soldering iron along with a cleaning sponge
• Stand for the tin
• Soldering iron 907I with tip T-B
• A gripper for lifting circuits
• Power cable

First run

• You should not run the device immediately after delivery.
• Equipment must remain for about 12 hours at room temperature before switching on.
• All complaints caused by running of the equipment too soon will be denied.

• You must completely remove the screw/screws from the bottom of the station if the compressor is the source of air supply. These screws are marked in red (1 or 3 screws depending on model).

Note

Heating elements (heaters) and tips are not subject to warranty, you should purchase new ones.

• soldering tin of various diameters
• fluxes and rosins
• braids to remove excess tin
• suckers
• soldering tips
• tweezers, holders, magnifying glass
• sponges and cleaners