HEAD RACKET X3 Balls Pressurizer + Pump Transparent

Recover the pressure of your tennis and padel balls with the new head x3 pump pressurizer with air pump. It is easy to use, economical and resistant. With a capacity of up to three balls. Head x3 pump is easy to use, fast and light. Introduce up to three tennis or padel balls inside the cylinder and screw the cover. Remember to place the o-ring to seal the air inside the head x3 pump and do not close all the way to make it easier to open. Insert the nozzle of the air pump into the valve of the product and pump with the tab raised until reaching a pressure on the gauge of 22 to 34 psi. Next, pull down the tab on the air pump and remove its nozzle. Done, your balls are recovering like new. By filling the free space with compressed air, we increase the internal pressure of the head x3 pump and thus the balls cannot eliminate their internal air, maintaining and recovering the original pressure until the next time they are used. Do not forget to remove the air through the valve using the plug before opening the head x3 pump again the new head x3 pump has been designed to recover the original pressure of tennis and padel balls, and keep them in perfect condition between matches. Thanks to its high-end valve, it is possible to inject air inside the cylinder and increase the pressure, allowing the balls to be fully recovered. Easy to use and resistant. It has a capacity of up to three balls, but it also works with fewer balls. Features: - Recover tennis and padel balls - Reduced size - Light weight - Easy to use with air pump - New improved design - Transparent to check the state of the balls - Includes O-ring and cap to protect the valve Specifications: - Weight: 361g / 12.73oz - Weight with air pump: 529 g / 18.65 oz - Length: 230 mm / 9.05 in - Deck width: 85 mm / 3.34 in - Cylinder width: 70 mm / 2.75 in Maintenance: - Disassemble the O-ring with something that is not sharp so as not to damage it, and clean it with a piece of paper. - Clean the cavity or hole where the O-Ring and the spiral are placed with a piece of paper. - Clean the inside of the Lid with a piece of paper. - Lubricate NOT IN EXCESS with Silicone Grease.