Programmer/debugger STM8/STM32 compatible with ST-LINK/V2 mini - Waveshare 10053

Description

The device is used as the programmer and debugger for STM8 and STM32modules. It works with voltages 3.3 V and 5 V, selectable by jumper. It has a built-in 500 mA fuse to prevent damage to the programmable modules.

 

Module with attached cable with 4-pin plug, common.

Specification

• Programmer / debugger modules STM8 andSTM32
• Output voltage 3.3 V and 5 V selectable with jumper
• Connecting to a computer via USB
• The programmer allows you to access Flash ROM, EEPROM, FAILURE rate, etc.
• The debugger supports step by step breakpoint functions, viewing variables and registers, etc.
• The possibility of firmware updates
• Supported software:
  • ST-LINK Utility v2.0+
  • STVD Version 4.2.1+
  • STVP Version 3.2.3+
  • IAR EWARM Revision v6.20+
  • IAR EWSTM8 Revision v1.30+
  • KEIL RVMDK Revision v4.21+
  • ATOLLIC
  • TASKS

 

Connection with PC

To connect with computer through the USB interface, you must installdrivers, which are available for Windows 7, Vista and XP. Currently, the manufacturer does not provide software for Windows 8 and 10.

Connection with STM8 / STM32

Connection with STM8 microcontrollers through the interface SWIM

 

Pin Code Of The Debugger Module Pin Description VCC MCU VCC The module power. SWM MCU SWIM Pin SWIM interface. GND GND Ground of the system. RST MCU RESET Reset.

 

Connection with STM32 microcontrollers through the SWD interface

 

The Pin Code Of The Debugger The Module Pin Description VCC MCU VCC The module power. SWDIO MCU SWDIO Pin SWD interface GND GND Ground of the system. SWCLK MCU SWCLK Line clock interface SWD.

 

Kit contents

• Programmer / debugger STM8 / STM32
• 1x 4-pin female cable
• USB A - USB A male female cable

Useful links

• The website of the manufacturer Waveshare
• Drivers for Windows XP/Vista/7
• User manual
• SoftwareST Visual Programmer STVP
• Software update ST-LINK