Step-Up Voltage Regulator U3V40F5 - 5V 4A - Pololu 4012

Бестселлер
53916960
1 606 ₽

Мы выстраиваем выгодные партнерские отношения с поставщиками товаров для строительства и ремонта Pololu и отобрали для вас лучших производителей брендовых товаров из Европы, Америки, Турции и ОАЭ, специализируясь на аутлетах и дискаунтерах. Прямая доставка из-за рубежа до покупателя нашими логистическими решениями — это оптимизированные и экономичные решения, вы не переплачиваете в цене товара за расходы на торговые помещения и шоурумы. Заказ будет отправлен напрямую с нашего склада по указанному вами адресу, по цене недоступной для местных магазинов.

Оригинальные брендовые товары в широком ассортименте с вкусными скидками — так можно описать наш интернет магазин. Доставка заказа будет отслеживаться на всех этапах покупки и работает сразу после оплаты заказа.

  • Бренд Pololu
  • Доставка из Польши
  • Пункт выдачи СДЭК 28 мая
  • Стоимость доставки заказа в Россию от 1 022 ₽

Сроки доставки указаны ориентировочно и зависят от региона доставки. Подробнее на этой странице

Характеристики

Напряжение от
5.0 V
Напряжение до
1.3 V
Стабилизатор - Тип
step-up
Выходное напряжение от
5.0 V
Выходное напряжение до
5.0 V

Прочие свойства

EAN
5904422382421
Бренд
Pololu
Номинальное выходное напряжение
5.0 V

Энергопитание

Сила тока
4.0 A

Описание

Product description: U3V40F5 - 5V 4A step-up converter - Pololu 4012

Pololu brand step-upconverter with an output voltage of 5 V and a capacity of 4 A. The supply voltage ranges from 1.3 V to 5 V (the starting voltage is 2.7 V). Typical inverter efficiency ranges from 90% to 95%, depending on input voltage and load. The module has temperature protection; when the temperature threshold is exceeded, it will shut down.

5 V / 4 A step-up converter pinouts.
Outputs of the step-up converter module

The step-up converter has four pin-outs in the form of six 2.54 mm solder holes.

  • EN - pin to disable the system when the voltage is below 0.4 V, system on by default: 30 kΩ resistor pulled up from EN to VIN.
  • VIN - input voltage from 2.7 V to 9 V (after starting up the chip, the input voltage may be at least 1.3 V).
  • GND - system ground (common for VIN and VOUT).
  • VOUT - output voltage 9 V.
Hazardous voltage pulses

When power is applied to the module, dangerous, short-lived high amplitude eclectic impulses (so-called pins) may appear, which can permanently damage the system. Pololu's tests show that for input voltages above 11 V pins can have amplitude large enough to damage the module. To protect against this undesirable phenomenon it is recommended to solder a capacitor of at least 33 uF as close as possible to the pins supplying the converter.

System efficiency

Efficiency is defined as the ratio of output power to input power (power out)/(power in). It is a very important parameter in the case of work with portable sources of energy (batteries and accumulators), where the time of work on one charging cycle counts. The efficiency of this circuit is from 90% to 95%. The output current depends on the input voltage and the system load.

Current efficiency of the U3V40F5 step-up converter.
U3V40F5 5 V / 4 A step-up converter, including goldpin connector kit.
U3V40F5 step-up converter specifications
  • Input voltage: from 1.3 V to 9 V (the minimum voltage to run the circuit is 2.7 V)
  • Output voltage: 5 V (with 4% accuracy)
  • Typical efficiency: 90% to 95%, depending on input voltage and load
  • Switching frequency: ~600 Hz at high load
  • Energy-saving mode
  • Typical no-load idle current less than 2 mA
  • The 9.5 amp switch allows for:
    • Instantaneous input current up to 9.5 A
    • Up to 4.5 A input current for a few seconds
    • up to 4 A input current for a longer time
  • Integrated protection:
    • shutdown due to over temperature
    • soft-start function limits the inrush current and gradually increases the output voltage
    • Output overvoltage protection (typically 16.5V)
    • input current limitation cycle by cycle up to 9.5 A
  • Dimensions: 15.2 x 15.2 x 5.6 mm
  • Weight: 1.5 g
Useful links
  • Manufacturer's website: Pololu #4012
  • Dimensions
  • 3D model

Доставка

Доставим товар из Германии от поставщика DESTE FZ LLC курьерской службой, в отделение Почты или пункт выдачи в вашем городе. Доставка в Армению, Казахстан, Грузию и Киргизию будет осуществлена доступными службами. Вы сможете выбрать желаемый способ доставки заказа в момент его оформления. Стоимость доставки зависит от выбранного вами метода и составит от 1 022 руб. Заказ будет доставлен за 10-30 дней, срок зависит от выбранного города. Если вы закажете этот товар прямо сейчас, доставим его 17 мая - 6 июня.

Доставка товаров для строительства и ремонта Pololu напрямую из Германии в Москву, Санкт-Петербург, Новосибирск, Екатеринбург, Казань, Нижний Новгород, Челябинск, Самара, Уфа, Ростов, Омск, Красноярск, Воронеж и другие города России осуществляется надежными и проверенными нами службами доставки.

Как только заказ будет отправлен к вам с нашего склада, отслеживание заказа по номеру посылки станет доступным.