USB programmer and debugger for Xilinx devices - Waveshare 6530

A platform that allows you to program and debugXilinxdevices via USB. The device is based onCY7C68013A+FPGAchip, which is compatible with original Xilinx platforms. It supports programming viaJTAG, Slave-Serial and SPIinterfaces. It works with 1.5 V/ 1.8 V / 2.5 V / 3.3 V / 5 V.

Programmer and debugger for Xilinx devices.

• Based on CY7C68013A+FPGA.
• Enables programming of any Xilinx FPGA / CPLDS / ISP PROM device.
• Supports programming by JTAG / Slave-Serial / SPI.
• Supports such voltages as: 1.5 V / 1.8 V / 2.5 V / 3.3 V / 5 V.
• Allows to change the clock frequency, automatically adjusts the frequency of Xilinx software.
• It automatically updates the software, so it will support next Xilinx devices.
• Antistatic and multi-layer signal isolation.
• Included are adapters and cables for connection to an official board or circuit.
• Supports software such as:
• • Xilinx ISE
  • iMPACT
  • ChipScope
  • Vivado
• Compatible devices:
  • Xilinx FPGA: UltraScale / 7 series / Zynq / Kintex / Virtex / Artix / Spartan, etc.
  • Xilinx CPLD: XC9500 / XC9500XL / XC9500XV / CoolRunner XPLA3 / CoolRunner-II, etc.
  • Xilinx PROM: XCF00S / XCF00P / XL, etc., etc.
• It has status LEDs:
  • Red: USB connected
  • Yellow: USB connected and Vref (target board) is powered

The programmer should be connected to the PC via USB and to the target board via the selected interface with a suitable cable. Below is a drawing of the pins layout.

Pin layout.

• USB programmer and debugger for Xilinx
• JTAG adapter
• USB cable
• 7-wire cable with 8-pin connector

• 6-wire cable with 8-pin connector

• JTAG 14-pin cable, raster 2.54 mm

• JTAG 14-pin cable, 2 mm raster

• JTAG 10-pin cable, raster 2.54 mm

Accessories included.

• The manufacturer's website: Waveshare 6530
• Product wikis
• Manual
• Software
• Documentation