VICTRON ENERGY Multiplus C 12/1600/70-16 Charger

VICTRON´s Energy MultiPlus C 12/1200/50-16 Inverter Charger brings toge ther, in a single compact housing, a powerful sine wave inverter, a sophisticated battery charger with adaptive technology and a high-speed AC transfer switch the Victron MultiPlus compact brings toge ther, in a single compact housing, a powerful sine wave inverter, a sophisticated battery charger with adaptive technology and a high-speed AC transfer switch.

Victron Multiplus Inverter Chargers are compatible with Lithium-Ion batteries.

Technical features.

Two AC outputs  the main output has a no-break function the MultiPlus takes over the supply to the connected loads in the event of a blackout or disconnection of the mains/generator the second output is only active when one of the MultiPlus inputs is supplied with AC power.

Devices that should not discharge the battery, such as a water heater, for example, can be connected to this output (second output available only on models with 50A transfer switch).

Virtually unlimited power thanks to parallel operation .

Up to 6 Multis can be operated in parallel to achieve higher power output and load.

Three-phase operation capability  in addition to parallel connection, three units of the same model can be configured for three-phase output.

But that´s not all:

up to 6 sets of three units can be connected in parallel.

PowerControl - Limited power from the generator, pontoon or mains  the Multi is a very powerful battery charger therefore, it will use a lot of current from the generator or the pontoon grid (almost 10 A per 5kVA Multi at 230 VAC).

A maximum current from the generator or pontoon can be set on the Multi Control Panel the MultiPlus will take the other AC loads into account and use the excess current for the load, thus avoiding overloading the generator or the pontoon network.

PowerAssist - Pontoon or generator electrical capacity increase .

This function takes the PowerControl principle to another dimension.

It allows the MultiPlus to supplement the capacity of the alternative source.

When peak power is required for a short period of time, as is often the case, MultiPlus will immediately compensate for the possible lack of power from the pontoon or generator current with power from the battery.

Variable four-stage charger and dual battery bank charging  the main output provides a powerful charge to the battery system by means of advanced ´´variable charging´´ software the software fine-tunes the automatic three-stage process to match battery conditions and adds a fourth stage for extended periods of slow charging in addition to the above.

The MultiPlus can charge a second battery.

Setting up the system couldn´t be simpler .

Once installed.

The MultiPlus is ready to go.

If the configuration needs to be changed, it can be done in a matter of minutes through a new DIP switch configuration procedure, or through the Victron software.