W5100S-EVB-PICO - board with RP2040 microcontroller and Ethernet - WIZnet

Бестселлер
61546847
2 394 ₽

Мы выстраиваем выгодные партнерские отношения с поставщиками электроники WIZnet и отобрали для вас лучших производителей брендовых товаров из Европы, Америки, Турции и ОАЭ, специализируясь на аутлетах и дискаунтерах. Прямая доставка из-за рубежа до покупателя нашими логистическими решениями — это оптимизированные и экономичные решения, вы не переплачиваете в цене товара за расходы на торговые помещения и шоурумы. Заказ будет отправлен напрямую с нашего склада по указанному вами адресу, по цене недоступной для местных магазинов.

Оригинальные брендовые товары в широком ассортименте с вкусными скидками — так можно описать наш интернет магазин. Доставка заказа будет отслеживаться на всех этапах покупки и работает сразу после оплаты заказа.

  • Бренд WIZnet
  • Доставка из Польши
  • Пункт выдачи СДЭК 2 июня
  • Стоимость доставки заказа в Россию от 851 ₽

Сроки доставки указаны ориентировочно и зависят от региона доставки. Подробнее на этой странице

Характеристики

Прочие свойства

Бренд
WIZnet

Описание

Product description: W5100S-EVB-PICO - board with RP2040 microcontroller and Ethernet - WIZnet

The WIZnet company board is equipped with a Raspberry Pi RP2040 microcontroller and an Ethernet TCP/IP W5100S system . W5100S-EVB-PICO supports wired Internet protocols such as TCP, UDP, WOL over UDP, ICMP, IGMPv1/v2, IPv4, ARP, PPPoE and up to 4 independent hardware sockets simultaneously . The RP2040 microcontroller has two ARM Cortex M0+ cores, operates at a frequency of up to 133 MHz, has 264 kB RAM (no EEPROM), 2 MB Flash memory and an external Quad-SPI flash memory with eXecute In Place (XIP). It has 30 multifunctional general purpose IOs (4 can be used as ADC).

W5100S-EVB-PICO - board with RP2040 microcontroller and Ethernet - WIZnet.

The W5100S-EVB-PICO by WIZnet is based on the microcontroller of the Raspberry Pi Foundation - RP2040.

Special features of the plate
  • Equipped with a Raspberry Pi RP2040 microcontroller and an Ethernet W5100S system
  • Includes built-in 12-bit 500 fs/s analog-to-digital converter (ADC)
  • Offers a wide range of interfaces - 2x UART, 2x I2C, 2x SPI, 16x PWM channels
  • Ability to emulate interfaces such as SD card and VGA
Module pins

The board uses the GPIO of the RP2040 microcontroller, which has the same pinout as the Raspberry Pi Pico board. The exceptions are the pins GPIO16, GPIO17, GPIO18, GPIO19, GPIO20, GPIO21 - in this case they are connected and reserved only for the W5100S system. These pins enable communication via the SPI interface with the W5100S when using the Ethernet connector. If you are using the Ethernet jack, these pins cannot be used for other purposes.

The manufacturer has also prepared a detailed user's guide , which contains a description of individual pins - check it out!

Description of the module pins. For more information on the individual pins, see the user's guide .

W5100S EVB Pico with Ethernet connection.

Technical specification of the RP2040 chip
  • Dual-core ARM Cortex M0+ clocked at 133 MHz
  • 264 kB onboard SRAM
  • 2 MB of flash memory
  • External Quad-SPI Flash with eXecute In Place (XIP)
  • 30 programmable IOs
  • 12-bit analog-to-digital converter (ADC) 500 fps
  • Communication interfaces: 2x UART, 2x I2C, 2x SPI, 16x PWM channels
  • SWD interface for debugging
  • 1x timer with 4 alarms, 1x RTC real time counter
  • Supported programming languages: C/C++ and MicroPython
  • Supply voltage: 5V
  • Operating voltage of the logic part: 3.3 V
  • Power / data connection: microUSB
Technical specification of the W5100S chip
  • Supports wired internet protocols: TCP, UDP, WOL over UDP, ICMP, IGMPv1/v2, IPv4, ARP, PPPoE
  • Supports up to 4 independent hardware slots simultaneously
  • Internal memory 16 kB for TX/RX buffers
  • SPI interface
  • MicroUSB connector (type B) for programming and power supply
  • ARM 3-pin serial debug (SWD) port
  • Built-in 10/100 Ethernet PHY
  • Built-in RJ45 connector (RB1-125BAG1A)
  • Built-in LDO regulator (LM8805SF5-33V)
Kit contents
  • W5100S-EVB-PICO - board with RP2040 microcontroller and Ethernet - WIZnet - 1 piece
  • Goldpin strip - raster 2.54 mm - 2 pieces

Components included in the set.

Useful links
  • Manufacturer's website: WIZnet W5100S-EVB-PICO
  • User Guide
  • Firmware and sample program codes
  • RP2040 technical documentation
  • W5100S technical documentation

Доставка

Доставим товар из Германии от поставщика DESTE FZ LLC курьерской службой, в отделение Почты или пункт выдачи в вашем городе. Доставка в Армению, Казахстан, Грузию и Киргизию будет осуществлена доступными службами. Вы сможете выбрать желаемый способ доставки заказа в момент его оформления. Стоимость доставки зависит от выбранного вами метода и составит от 851 руб. Заказ будет доставлен за 10-30 дней, срок зависит от выбранного города. Если вы закажете этот товар прямо сейчас, доставим его 22 мая - 11 июня.

Доставка электроники WIZnet напрямую из Германии в Москву, Санкт-Петербург, Новосибирск, Екатеринбург, Казань, Нижний Новгород, Челябинск, Самара, Уфа, Ростов, Омск, Красноярск, Воронеж и другие города России осуществляется надежными и проверенными нами службами доставки.

Как только заказ будет отправлен к вам с нашего склада, отслеживание заказа по номеру посылки станет доступным.