W6100-EVB-Pico - RP2040 microcontroller and Ethernet board - WIZnet

Board manufactured by WIZnet and equipped with a Raspberry Pi RP2040 microcontroller and an Ethernet TCP/IP W6100 system. W6100-EVB-PICO supports wired Internet protocols such as TCP, UDP, IPv6, IPv4, ICMPv6, ICMPv4, IGMP, MLDv1, ARP, PPPoE and up to 8 independent hardware sockets with 32 kB memory. It supports two types of HOST interfaces - SPI and BUS parallel system. The RP2040 microcontroller has a dual-core ARM Cortex M0+ processor operating at a frequency of up to 133 MHz, 264 kB of RAM (no EEPROM) and an 8 MB SPI Flash chip for storing files.

W6100-EVB-Pico - board with RP2040 microcontroller and Ethernet - WIZnet.

The board has solder pads to which the included connectors should be soldered.

• Equipped with a Raspberry Pi RP2040 microcontroller and an Ethernet W6100 system
• Has 30 multifunctional general purpose IOs (4 can be used as ADC)
• Includes built-in 12-bit 500 fs/s analog-to-digital converter (ADC)
• Supports wired internet protocols: TCP, UDP, IPv6, IPv4, ICMPv6, ICMPv4, IGMP, MLDv1, ARP, PPPoE
• It simultaneously supports 8 independent SOCKET sockets with 32 KB memory
• It has an internal memory of 16 kB for TX/RX buffers
• It uses the SPI interface

• Dual-core ARM Cortex M0+ clocked at 133 MHz
• 264 kB onboard SRAM
• External Quad-SPI Flash with eXecute In Place (XIP)
• 12-bit analog-to-digital converter (ADC) 500 fps
• Communication interfaces: 2x UART, 2x I2C, 2x SPI, 16x PWM channels
• SWD interface for debugging
• 1x timer with 4 alarms, 1x RTC real time counter
• Supported programming languages: C/C++

W6100-EVB-Pico has an Ethernet connector and a USB C port.

• Supports wired internet protocols: TCP, UDP, IPv6, IPv4, ICMPv6, ICMPv4, IGMP, MLDv1, ARP, PPPoE
• Supports IPv4/IPv6 dual stack
• Simultaneously supports up to 8 independent hardware sockets with 32 kB memory
• Supports socketless commands: ARP, PING, ICMPv6 commands (PING, ARP,DAD,NA,RS) for IPv6 auto-configuration and network monitoring
• Supports Ethernet power off mode and system clock switching to save power
• Supports Wake on LAN over UDP
• 16 KB internal memory for TX/RX buffers
• Auto-negotiation support (full and half duplex, 10 and 100 based)
• Support for Auto-MDIX only in auto-negotiation mode
• Does not support IP address fragmentation
• 3V power supply with 5V I/O signal tolerance
• SPI interface
• MicroUSB connector (type B) for programming and power supply

• W6100-EVB-Pico - board with RP2040 microcontroller - WIZnet
• Goldpin strip - raster 2.54 mm - 2 pieces

Components included in the kit .

• Manufacturer's website
• User Guide