Z-Uno 2 - plate is Z-Wave compatible with Arduino
- Product Code:
- 42758803
Properties
- UC - I2C
- yes
- UC - RAM
- 2 kB
- UC - WiFi
- yes
- UC - UART
- yes
- UC - ядро
- 8-bit AVR, 1. Single Core
- Voltage To
- 4.0 V
- Voltage From
- 18.0 V
- UC - frequency
- 16 MHz
- UC - SPI Interface
- yes
- UC - microcontroller
- ATmega328
- Выходное напряжение от
- 5.0 V
- Выходное напряжение до
- 5.0 V
- UC - Цифровые контакты
- 26
General characteristics
- UC - PWM
- 4
- UC - аналог в
- 4
Other features
- Brand
- Z-Wave
- Nominal output voltage
- 5.0 V
Description
Module linking capabilities of the Protocol Z-Wave and Arduino board. Compatible with the popular Arduino Nano, it has a ATmega microcontroller with installed bootloader. This means that it can be programmed throughthe Arduino IDE development environment using available libraries. The plate containsa USB-UART converter, which allows to program the module by connecting itdirectly to the computer USB port.
The module has a microcontroller, and is equipped with 26 digital inputs/outputs, 5 of which can be used as PWM outputs (e.g. for controlling motors) and 4 as analog inputs. The system works with the signal ticking with the frequency of 16 MHz. The module also has a microUSB port, a RESET button and a user's button.
The manufacturer provides aguide for installingdrivers for the Arduino IDE.
Programming
Creating and installing software is enabled in the free development Arduino IDE environment. Implemented bootloader allows you to send program directly through the USB cable. A detailed description can be found inthe tutorial.
Specification
- Supply voltage: 5V to 18V
- Outputs operate at a voltage of 5 V
- Installed bootloader Z-Uno compatible with Arduino IDE
- Z-Wave[rotocol support
- Built-in aerial
- Microcontroller: ATmega 328
- Maximum clock frequency: 16 MHz
- SRAM memory: 2 KB
- Flash memory: 32 KB (4 KB is reserved for bootloader)
- EEPROM memory: 64 KB
- I/O Ports: 26
- PWM outputs: 5
- Number of analog inputs: 4 (channels Converter A/C)
- Serial interfaces: UART, SPI, I2C
- External interrupt
- 2 timers
- 1-wire
- Connector: microUSB
- Compatible with Fibaro JHome Center 2 / Lite Edge Vera, Zipato Zipabox
- Dimensions: 40 x 20 mm
- The manufacturer's website
- User manual
- Installing the Arduino IDE
- Description of the Protocol Z-Wave
