Quick connector with solder + heat shrink foil 12-10AWG 4-6mm2 - 5pcs.

Heat shrinkablequickconnector with fusedtin. It has a length of40mm and internal diameter of8 mm,it has a ring with tin embedded in the tube. It is designed to connect wires with cross-section from 4 to 6 mm2. Heat the tube to above80°C.The tin will start to melt and permanently connect the wires together. Inside the quick connector is an extra layer of glue that protects the wires from moisture. No more insulation is needed for the wires.

Quick connector with tin + heat shrink foil 12 - 10 AWG 4 - 6 mm2.

Instructions on how to properly connect the quick connector to the wires.

1. Remove the insulation from the ends of the two wires.
2. Run one of the wires through the quick-connector.
3. Connect the two wires together and place the tin strip in the center of the quick disconnect.
4. Weld the heat shrink tubing.

• Connects wires without soldering
• Seals and insulates wires against water, dirt and disconnection
• Contains inside thermo-melting glue

• Insulating material: polyolefin
• Working temperature: from -55°C to 125°C
• Tube shrinking temperature: 80°C
• Additional adhesive layer
• Colour: yellow
• Cable cross-section: from 4 to 6 mm2
• Outer diameter: 8 mm
• Inner diameter: 7 mm
• Tube length: 40 mm

Set contains 5 pieces of quick disconnects.