Thermal imaging camera - FLiR Lepton Dev Kit V2 - SparkFun KIT-15948

Bestseller

Product Code:: 54170634

Thermal imaging camera - FLiR Lepton Dev Kit V2 - SparkFun KIT-15948

1,897 GEL

Brand SparkFun
Shipping from Poland
Post delivery July 20
Shipping cost for orders to Georgia from GEL 193

Properties

Датчик - Температура от: 0 °C - 70 °C

General characteristics

Voltage To: 3.0 V
Voltage From: 5.5 V
Датчик - Температура до: 50 °C

Other features

Brand: SparkFun

Picture quality

Camera Type: module

Description

Product description: Thermal imaging camera - FLiR Lepton Dev Kit V2

A kit containing the Flir Lepton V2 thermal imaging camera, and a board to facilitate its connection. The Lepton LWIR radiometric module has a resolution of 80 x 60 px and registers infrared radiation of wavelength range from 8 μm to 14 μm. An SPI interface is required to read the image. The I2C bus is used to configure the camera, although it is not absolutely required. The device is powered from 3 V to 5.5 V.

Lepton Dev Kit V2 is compatible with Arduino and Raspberry Pi microcomputers.

FLiR Lepton Dev Kit camera presentation.

Dimensions of the FLiR Lepton V2 thermal imaging camera module.

Specifications FliR Lepton V2

Wavelength range: 8 μm to 14 μm
Measurement angle:
- For diagonal mode: 60°
- For HFOV mode: 50°
Thermal sensitivity: up to 50 mK
Resolution: 80 px (h) x 60 px (v)
Single pixel size: 17 μm
Frame rate: 9 Hz
Frame rate: 9 Hz Image timeout: less than 1.2 seconds
Average power consumption: approximately 150 mW
Available interfaces:
- SPI
- I2C
Supply voltage: from 3.0 V to 5.5 V

Warning!

The module is sensitive to electrostatic discharge. Ensure proper grounding before installation.

Lepton V2 pinout and description

The FLiR Lepton Dev Kit V2 thermal imaging camera, has 20 pins to connect the wires. Their diagram and description is illustrated by the following graphics.

Schematic and pinout of the module.

Comparison of the FLiR Lepton and FliR Lepton V2 Models Comparative specification Model: EFLiR Lepton Dev Kit EFLiR Lepton Dev Kit V2 Resolution: 80 x 60 px 80 x 60 px Wavelength range:

8 μm to 14 μm

Measuring angle for HFOV mode: 51°C 50°C Thermal sensitivity up to 50 mK up to 50 mK Frame rate less than 9 Hz less than 9 Hz Control interface: I2C I2C Video interface: SPI

SPI

Image waiting time:

less than 0.5 s

less than 1.2 s

Integrated shutter: no yes Metering angle for HFOV mode: 51°C 50°C Average power consumption approx. 150 mW approx. 150 mW Supply voltage: 3.0 V to 5.0 V 3.0 V to 5.5 V Contents of the kit